Nitrous Cobra Dyno Day

Well, immediately after AJ's dyno runs, we put the cobra on the lift and installed the bottle in the trunk, ran the nitrous line up into the engine bay. Next we installed the digital window switch and fabricated a bracket that looks damn near stock, it holds a microswitch for the WOT switch for the nitrous. removed the test port on the fuel rail, installed the fuel feed line... Wired up the tach signal driver, connected the microswitch to the digital window switch, and connected the nitrous lines, after all of this we removed the intake plenum and drilled and tapped it for the wet nozzle that we used on the rental car actually. Got it in and installed with no problem at all. Tested all of the wiring and everything looked good. We installed 50shot jets and rolled it off the lift and onto the dyno. What happened next was surprising to say the least. Even though its known that cobras with the blowers make insane power on small amounts of spray it was still stunning to see on a 50 shot it made 73whp and 72ftlbs and the 100 shot it made 134whp and 177ftlbs INSANE!

• Stock Pull: 460RWHP 527RWTQ
• 50 Shot: 533RWHP 599RWTQ
• 100 Shot: 594RWHP 704RWTQ

Installation Pictures:

Here is the dyno charts overlayed.

Here is a Video of the dyno runs and more.